How to use the hydraulic truck

Update:Jul 15,2022

Summary:1. Before use, make sure that the hydraulic truck is pressurized, lowered, and the wheels and other devices are intact;2. The height of the hydraulic ...

1. Before use, make sure that the hydraulic truck is pressurized, lowered, and the wheels and other devices are intact;
2. The height of the hydraulic truck should be less than 2CM, otherwise the goods will be shaken or dumped during the operation;
3. In order to avoid uneven force on both sides and safety accidents, the hydraulic truck should be inserted into the center of the tray;
4. According to the size of the pallet to be transported, select a hydraulic truck with suitable shovel arm spacing, and the bottom of the pallet should be loose and unobstructed;
5. When loading, make sure that there is a certain gap between the cargo, the door and the inner wall of the compartment, and the distance is 5-10CM;
6. Use even force when handling and turning to keep the goods stable, especially on poor roads such as wet, inclined, etc., be more careful when driving;
7. After the goods are in place, put them down gently and be careful when pulling out the hydraulic truck.
Manual Hydraulic Vehicle Maintenance Instructions
Common faults and maintenance methods of trucks.

Pallet truck failure phenomenon and analysis:
Phenomenon 1: The fork does not rise to the highest level Reason: insufficient hydraulic oil Maintenance method: add hydraulic oil
Phenomenon 2: The fork does not rise Cause: There are impurities in the hydraulic oil, the pressure relief valve is not adjusted properly, and there is air in the hydraulic oil. Maintenance method Replace the clean hydraulic oil, adjust the set screw, and remove the air
Phenomenon 3: The fork does not descend Reasons: the piston rod of the cylinder is deformed due to eccentric load, the parts are damaged or deformed due to the eccentric load, the pressure relief valve is not adjusted properly, and the maintenance method is replaced. set screw
Phenomenon 4: Leakage Reason: worn or damaged seals, cracked or worn parts Repair methods: replace new seals, check and replace new parts

PREV:What are the manifestations of electric forklift failures?
NEXT:How about a forklift?